Research.
Documented.
Traceable.
Every released lot is paired with the laboratory that tested it, the method and the version used, the sample and report dates, and the measured result with its units.
Every layer
is a field
The object is the record. Each sheet holds one part of it: where the material came from, who handled it, which method was run, what the laboratory reported, and every revision since.
Numbers,
not verdicts
A measurement is published with its method, its units and its date. Laboratory data is not turned into a guarantee, a conclusion or a pass mark.
Research materials
Each listing carries the lot currently released against it, the method that produced the result, and the date it was reported. Open the record to read the report itself.
Single peptide
BPC-157
Single peptide
TB-500
Blend
BPC-157 + TB-500
Single peptide
GHK-Cu
Single peptide
Ipamorelin
Single peptide
CJC-1295 (no DAC)
GLP-1 research
Semaglutide
GLP-1 research
Tirzepatide
Single peptide
PT-141
Cognitive
Selank
Single peptide
Epithalon
Supplies
Bacteriostatic Water
All materials supplied for in vitro laboratory research only · not for use in humans or animals
What a lot
record contains
A product name tells you what was ordered. The lot tells you what was supplied. Each released lot is given its own identifier and its own permanent record, and the record is where the detail lives.
Documents stay attached to their lot. Corrections are dated. Superseded files stay reachable. Where a field is not yet part of the record, it is named below rather than left out.
Open the evidence
Do not take a product page on faith. Select a lot to read the laboratory, the method, the dates, the measured result and the documents held against it.
- Catalog
- BLP-1104-05
- Form
- 5 MG · LYOPHILISED
- Laboratory
- Janoshik Analytical
- Scope
- ISO/IEC 17025 · HPLC-UV
- Method
- HPLC-07 · rev 3
- Sampled
- 2026-07-14
- Reported
- 2026-07-21
- State
- Available
- Result
- 99.2 % by HPLC-UV, 214 nm
The result is the chromatographic purity of the sample submitted for this lot, by the stated method on the stated date. It describes that sample and no other, and it says nothing about behaviour in any system.
- Catalog
- BLP-1104-10
- Form
- 10 MG · LYOPHILISED
- Laboratory
- Janoshik Analytical
- Scope
- ISO/IEC 17025 · HPLC-UV
- Method
- HPLC-07 · rev 3
- Sampled
- 2026-06-02
- Reported
- 2026-06-09
- State
- Superseded · corrected 2026-06-19
- Result
- 98.7 % by HPLC-UV, 214 nm
Revision 1 carried a transcription error in the sample receipt date. Revision 2 corrects it. The superseded file stays published beside the current one and is not deleted.
- Catalog
- BLP-2207-02
- Form
- 2 MG · LYOPHILISED
- Laboratory
- Colmaric Analyticals
- Scope
- ISO/IEC 17025 · ESI-MS
- Method
- MS-02 · rev 1
- Sampled
- 2026-05-21
- Reported
- 2026-05-27
- State
- Available
- Result
- Observed mass within 0.4 Da of calculated
Mass agreement supports the stated sequence for the submitted sample. Purity was not part of this submission and is not reported for this lot.
- Catalog
- BLP-1104-05
- Form
- 5 MG · LYOPHILISED
- Laboratory
- Not yet assigned
- Scope
- Pending submission
- Method
- HPLC-07 · rev 3
- Sampled
- 2026-07-24
- Reported
- Not reported
- State
- Held · pending test
- Result
- Not reported. Sample in transit to laboratory
This lot is held and is not offered. The purity and identity fields are empty because the test has not been run, and they will stay empty until the laboratory issues the report.
- Catalog
- BLP-2207-05
- Form
- 5 MG · LYOPHILISED
- Laboratory
- Colmaric Analyticals
- Scope
- ISO/IEC 17025 · HPLC-UV
- Method
- HPLC-07 · rev 2
- Sampled
- 2026-03-11
- Reported
- 2026-03-18
- State
- Withdrawn 2026-04-04
- Result
- 96.1 % by HPLC-UV, 214 nm
Withdrawn after a packaging discrepancy was reported by an account. The record stays public, the measured result stays as issued, and the withdrawal notice states the scope of the withdrawal.
Methods, and what
they do not establish
A method answers one question about one submitted sample on one date. The column on the right is the part usually left off, and it is the part that tells you what a result is worth.
How BLP writes
things down
Five rules the catalog, the packaging, the emails and the support replies are all held to.
The lot is the product
A product name tells you what was ordered. The lot tells you what was supplied. Every released lot gets its own identifier and its own document record.
Open the evidence
The laboratory, the method, the sample date, the measured result, the report and the document history are published on the lot page, not summarised into a sentence.
Numbers, not verdicts
A measurement is reported with its method, its units and its date. Laboratory data is not turned into a guarantee, a conclusion or a pass mark, and no result is printed without the method that produced it.
Records that survive scrutiny
Documents stay attached to their lot. Corrections are dated and the superseded file stays reachable. Where information is missing, the record says so instead of leaving the field out.
Access has a standard
Material is supplied for in vitro laboratory research. Product selection, pairing, fulfilment, support replies and documentation are held to that context without exception.
Access has
a standard
BLP supplies material for in vitro laboratory research. Product selection, communication, fulfilment and documentation are all held to that context. Wholesale accounts are opened after the account details are checked against it.
For in vitro laboratory research only.
Not for use in humans or animals.
Not for clinical or diagnostic use.
Restrict access to trained laboratory personnel.
Bacteriostatic water, syringes, needles, dosing charts and reconstitution cards are not sold, bundled or shipped by BLP.